|
Post by Dennis on Jun 8, 2016 8:25:32 GMT -4
Can you put a CDI ignition from a 50cc(BraveHeart Engine) gas engine on a 30cc(Turnigy) gas engine!
I had twitching servos with the 30cc cdi and was hard to start, so I had a 50cc cdi on hand, so I tried it and it works. Both have CM-6 plugs.
Is this wrong or OK???
Thanks Dennis
|
|
|
Post by Dennis on Jun 8, 2016 10:14:22 GMT -4
After searching I found they are both made by Rexel and are both modelA-01 version 2, so I think they are the same
|
|
|
Post by steve on Jun 8, 2016 14:48:48 GMT -4
Dennis,
Twitch servos may be a problem with a loose connection on your plug to wire connection from your ignition. That may create a lot of interference. I had that same problem on my Zenoah g23 boat motor. I had serious issues with controls that drove me nuts. Turns out I had a loose connection at the plug. I actually used a small hose clamp on it and voila, the problem disappeared. I ordered a new spring (not worth what it cost to get it here) that sits in the boot of the spark wire. That worked and allowed me to get rid of the ugly hose clamp. Your ignition may be okay but with a loose connection?. My spring was actually broken. I bet you can remove and squeeze it abit. Worth a try
|
|
|
Post by Dennis on Jun 8, 2016 19:50:56 GMT -4
I was getting irregular spark as I tested it with my hand turning the shaft without prop on , and was also getting a little shock on my hand from the cdi box . Thanks Steve, I'll check it again Dennis
|
|